8.75 inches long drop point blank blade, hand forged twist pattern Damascus steel blank blade skinning knife with 3 Pin hole & finger groove, 4.5 inches cutting edge

Blade is made of Damascus steel by forging the 1095 and 15N20 high and low carbon steel Our Damascus steel is prepared by forging over 465 layer of high carbon and low carbon steel. Blade has been given an excellent heat treatment to get it well hardened. Hardness 56 to 58 HRC. Tips to Care Damascus knife: Damascus steel as well as 1095 high carbon steel knives are different than some other common steel knives because of its high carbon content they can be rusted if not care properly. If you have seen rust accidentally then use WD40 to remove it. Never store your knife for long time in leather sheath. Leather can absorb water which will rust the knife. Always clean the blade after using and apply oil or wax (please use cooking oil on Chef Knife) before you store it, for its longer life and durability.

• Overall 8.75 inches Long hand forged twist pattern damascus steel blank blade
• 4.25 inches long scale space with 3 pins and a finger groove
• 4.75 inches long drop point blade with 4.25 inches cutting edge. Up to standard skinning Knife
• Approximately 4.5 mm Thick Twist pattern Damascus drop point blade.
• Our Damascus steel is prepared by forging over 200 layer of high carbon and low carbon steel. The blade has been tempered, grinded and given an excellent heat treatment. Our tested hardness is 56-58 HRC.